1. Electronic Case Assembly Step #10 History

Changes to Step #10

Edit by Dan Royer — Feb 3, 2020

Edit approved by Dan Royer

	[title] Power Supply Installation - Rocker Switch Test
	[* 2] Secure the *Power Cable* to the PSU Screw Terminals
	[* 3] ++Test the Rocker Switch and PSU++ by connecting the Power Plug and turning the Switch ON
+	[* 9] Be careful to NOT touch the screw terminals with your bare hands.
	[* 5] If the Green LED light turns on, it's a good sign
	[* 8] Use the Multimeter to make sure the output voltage is *approximately 24V*, adjust using the Philip Head Screw
	[* 6] Left 3 terminals are Positive Output
	[* 7] Middle 3 terminals are Ground/Negative Output
-	[* 9] Once test is successful, *Turn off the Power using the Switch and unplug* the Power Plug
+	[* 1] Once test is successful, *Turn off the Power using the Switch and unplug* the Power Plug