Changes to Step #9

Edit by Dan Royer —

Edit approved by Dan Royer

Before
After
Unchanged

Step Lines

[title] Power Supply Installation - Rocker Switch Installation
[* 1] Insert the Rocker Switch into the Case.
[* 2] Some version of Rocker Switch has smaller mounting holes, if this is the case, M4 Fasteners will no longer be viable
[* 3] Therefore use the ***M3x10mm Screws, Washers and Nylock Nuts***
[* 5] Secure the Rocker Switch with the fasteners
-[* 10] Notice the Soldering Patterns
- [* 6] 18AWG Power Wires xmm long
- [* 8] 3 Wire Power Cable x mm long
+[* 10] Notice the Soldering Patterns AND Length
+ [* 6] 18AWG Power Wires ***65mm*** long
+ [* 8] 3 Wire Power Cable ***365mm*** long