Changes to Step #4

Edit by Dan Royer —

Edit approved by Dan Royer

Before
After
Unchanged

Step Lines

[title] Final assembly
+[* 10] We do not supply the board on which you will draw. It should be square, flat, and smooth. Measure it and mark the center for later. The board pictured is 600mm*600mm and is good for an A4 drawing.
[* 2] tighten the clamp screws to hold the motors on each corner. the first motor is NW, the second NE, the third SW, the fourth SE. The order is very important!
[* 4] Feed timing belt around a pulley, through the idlers, and out to the pen holder. Maintaining tension is crucial to accurate drawings.
[* 3] Attach the servo extension cable to the servo. The extension cable white/red/black should connect to the servo orange/brown/red.
[* 5] Alligator clips are a great way to hold your paper down during drawing, and can also make sure the servo cable does not catch on anything.