Changes to Step #3
Step Lines
| + | [title] Connect wires to controller |
|---|---|
| + | [* 5] Connect female power plug, red wire to +. |
| + | [* 2] Attach LCD cables. Note orange and red cables swap sides AND flip over. Same as Makelangelo. If power is connected the LCD will only light up in the correct wiring. |
| + | [* 4] If required, with power off, remove all four driver chips and make sure all three DIP switches are pressed down. |
| + | [* 6] With power off, adjust the dial on each chip. A multimeter reading between the dial and the bottom right pin of each chip should read 0.17v when power is on. DO NOT turn the dial when power is on. |
| + | [* 8] With power off, connect each motor. The yellow wire must be on the left. |
| + | [* 7] Connect the servo extension cable to pins in the EXP3 zone. There is a small black arrow on the right end of EXP3. The cable connects on the bottom row, with the black wire on the right (one pin under the arrow) |
Image 1
No previous image
Added