Skip to main content

Site Navigation

Your Account

Choose Language

  1. Moist all 4 suction cups and press the main board against  a vertical,flat and clean window or glass. Try to place Makelangelo as level as possible, at least 110cm (44") above any interference (such as a window frame)
    • Moist all 4 suction cups and press the main board against a vertical,flat and clean window or glass.

    • Try to place Makelangelo as level as possible, at least 110cm (44") above any interference (such as a window frame)

  2. Prepare the belt with the counterweights and insert it onto motor pinion gear. Try approaching the pinion gear sideways as shown in the picture for easy belt installation. Make sure the belt sits firm on the pinion gear. Make sure the belt sits firm on the pinion gear.
    • Prepare the belt with the counterweights and insert it onto motor pinion gear. Try approaching the pinion gear sideways as shown in the picture for easy belt installation.

    • Make sure the belt sits firm on the pinion gear.

  3. Connect weights to pen holder arms using provided hooks. Make sure arms move smoothly when running, if not, sand down the contacting surface of arm rings.
    • Connect weights to pen holder arms using provided hooks.

    • Make sure arms move smoothly when running, if not, sand down the contacting surface of arm rings.

  4. Slide in a sharpie and secure it with the screw. The tip should be pointing out just enough to touch painting surface when mini-servo is not in the extended position Slide in a sharpie and secure it with the screw. The tip should be pointing out just enough to touch painting surface when mini-servo is not in the extended position
    • Slide in a sharpie and secure it with the screw. The tip should be pointing out just enough to touch painting surface when mini-servo is not in the extended position

  5. Connect servo cable and USB cable Start drawing!
    • Connect servo cable and USB cable

    • Start drawing!

  6. Locate one of the corner holes for suction cups. Press firmly with your thumb and twist the cup until the end fits into the wood. Turn the tab outward for easy release later
    • Locate one of the corner holes for suction cups.

    • Press firmly with your thumb and twist the cup until the end fits into the wood.

    • Turn the tab outward for easy release later

    • Moisten the cup before attaching to glass. This will greatly increase the holding power.

Finish Line

Dan Royer

Member since: 02/13/2019

1,656 Reputation

9 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 2

Past 7 Days: 9

Past 30 Days: 30

All Time: 161